Free guide

Confined space entry and rescue: what must be in place before anyone goes in

Last reviewed:

Nobody enters a confined space until a written entry permit has been issued by a competent person, a standby person is outside keeping continuous contact, and rescue procedures are set up and practised. If the work is construction work, a Safe Work Method Statement (SWMS) is also required, but it sits beside the permit and does not replace it.

These rules exist because the atmosphere inside a confined space can become deadly without any warning you can see or smell, and because an untrained rescuer who goes in after a collapsed worker faces the same atmosphere.

What is a confined space?

Under the model WHS Regulations, a confined space is an enclosed or partly enclosed space that is not designed or intended mainly for people to be in, is at normal atmospheric pressure while people are in it, and is or is likely to be a risk to health and safety from an unsafe oxygen level, contaminants that may cause fire or explosion, harmful concentrations of airborne contaminants, or engulfment. Tanks, pits, sewers, silos, some trenches, ceiling and roof spaces, risers and vaults can all be confined spaces. Whether a space counts depends on its features, so check the definition in the model Code of Practice: Confined spaces and do not decide by the name of the space.

The model WHS Regulations also require a risk assessment, done by a competent person, before anyone works in a confined space. See what is a risk assessment?

What must the entry permit contain?

Under the model WHS Regulations, a person conducting a business or undertaking (PCBU) must not direct a worker into a confined space without a permit. The permit must be completed by a competent person, be in writing, and specify:

It must also have space to confirm the work is finished and everyone has left. When the work is done, the competent person completes that acknowledgement.

Signs must be up next to each entry while the work is prepared, carried out and finished. They identify the space and tell workers not to enter without a permit.

What does the standby person do?

The model WHS Regulations require continuous communication with the worker from outside the space, and a standby person near the space monitoring conditions inside and, if practicable, watching the work. The model Code of Practice says the standby person should:

SafeWork NSW says the same: the standby person continuously monitors from outside the space.

What about rescue?

The PCBU must set up first aid and rescue procedures for an emergency in the space, and practise them as often as needed to make sure they work. In an emergency, the procedures must be started from outside the space as soon as practicable.

The entry and exit openings must be big enough for emergency access and kept clear, and the rescue and first aid equipment must be kept in good working order. “Call 000” is not a rescue plan on its own. Work out how a person will be retrieved, by whom, with what equipment, and how long it will take.

What about the atmosphere?

The model WHS Regulations set specific controls for confined spaces: isolating connected plant and services, purging or ventilating contaminants, keeping a safe oxygen level, keeping flammable gases and vapours below 5% of their lower explosive limit, and controlling ignition sources. In practice that means gas testing before and during entry, ventilation, isolation and lock-out, and respiratory protection where needed. See what are WES and WEL? for the exposure limits.

Where does the SWMS fit?

Construction work “carried out in or near a confined space” is one of the 18 categories of high risk construction work. If your job is construction work in or near a confined space, a SWMS must be prepared before it starts.

The SWMS covers how the task is done and controlled: the steps, the hazards, the controls, and how they are monitored and reviewed. The entry permit authorises a specific entry, by named people, for a set time. The rescue procedure says what happens if it goes wrong. You need all three, and they should agree with each other. For writing the SWMS itself, see how to write a SWMS. For whether you need one, see do I need a SWMS?

How long do you keep the paperwork?

Under the model WHS Regulations:

They must be available for inspection and to any relevant worker who asks.

What about Victoria?

Victoria has its own confined space requirements under the Occupational Health and Safety Regulations 2017 and a Compliance Code: Confined spaces. The rules are similar in purpose but worded differently, so check WorkSafe Victoria’s confined spaces page before relying on the model rules above.

Confined space SWMS pack

The Confined Space Entry trade pack includes 11 SWMS, including Confined Space Entry, Confined Space Standby & Rescue, Gas Testing & Atmospheric Monitoring, Risers - Working In, Water Jetting Drains and Grain Silo Entry. It is $249.99 per state, editable Word, one-off purchase.

The Confined Space Entry and Rescue Plan is a separate $149 template for the site-level plan. Neither replaces the entry permit or the risk assessment for each entry. Other trade packs, such as Civil Works and Electrical Combined HVAC and Solar, also include a confined space SWMS for those trades. See which SWMS pack do I need?

Common questions

Who can issue a confined space entry permit?

Under the model WHS Regulations, the permit must be completed by a competent person and be in writing. It names the space, the people allowed to enter, the time period and the control measures, and it has space to sign off that the work is finished and everyone is out.

Can the standby person go in to rescue someone?

No. The model Code of Practice says the standby person should stay outside, have the authority to order workers out, and never enter the space to attempt a rescue. Rescue procedures must be started from outside the space.

Do I need a SWMS for confined space work?

Construction work carried out in or near a confined space is high risk construction work, so a Safe Work Method Statement (SWMS) is required before it starts. The SWMS does not replace the entry permit, the risk assessment or the rescue plan.

How long do I keep the permit and risk assessment?

Under the model WHS Regulations, keep the entry permit at least until the work is completed, and the risk assessment until at least 28 days after the work is completed. If a notifiable incident occurs, keep both for at least 2 years after it.

Sources: Model WHS Regulations, Part 4.3, Model Code of Practice: Confined spaces, SafeWork NSW—Confined spaces and WorkSafe Victoria—Confined spaces. General information only; check the requirements in your jurisdiction with your regulator.

Start from a proper SWMS, not a blank page

State-specific, editable templates written for your state. Download instantly, then make it yours for the job and the site.

This guide is general information, not legal or safety advice, and does not guarantee compliance. Laws and site conditions vary, so always check your state regulator and have documents reviewed by a competent person.