Free guide

Quad bike safety at work: what the newly agreed WHS reforms mean and what to do now

Last reviewed:

A majority of work health and safety (WHS) ministers have agreed to progress six reforms to quad bike safety at work, Safe Work Australia announced on 17 November 2026. The proposals include operator protection devices on all workplace quad bikes, compulsory helmets at work, no passengers on operator-only quad bikes, and a minimum rider age of 16. These are agreed reforms to the model WHS Regulations, not amendments that are already in force. Safe Work Australia still has to draft those amendments, ministers have to approve them, and each state and territory that uses the model laws then has to adopt them. Some workplaces already have overlapping rules. Queensland already requires a minimum operator and passenger age of 16 (or a different age recommended by the manufacturer), a crash helmet, and no passengers unless the bike is designed for them (Work Health and Safety Regulation 2011 (Qld) ss 226A to 226C). Tasmania already requires an approved helmet, training, and no passengers unless the bike is designed to carry a seated passenger (Work Health and Safety Regulations 2022 (Tas) r 216A).

Your duties under the current law have not changed, though, and they already cover most of what the reforms propose. This guide sets out what was agreed, what happens next, and practical steps you can take now under your existing duties.

What did WHS ministers agree?

According to Safe Work Australia, the proposed reforms include:

The first four would add specific rules to the model WHS Regulations. In some jurisdictions, overlapping workplace rules already apply (see below). The last two are government actions: better data on incidents and safety campaigns aimed at quad bike users.

SafeWork SA published the same list on 18 November 2026, describing them as "national reforms to strengthen quad bike safety at work".

Why now?

The numbers are going the wrong way. Safe Work Australia reports that between 2021 and 2025, 73 people died in quad bike incidents, an average of almost 15 deaths a year. As at 5 November 2026, 17 quad bike fatalities had been recorded in 2026, already more than the five-year annual average. A different Safe Work Australia page, the agriculture duties tool, reports 88 quad bike deaths in Australia between 2020 and 2024. This guide uses the 17 November 2026 news figures (73 deaths between 2021 and 2025) and does not mix the two counts, because they cover different periods and may not be directly comparable.

SafeWork SA adds that most incidents occur when quad bikes roll over, throwing riders off or trapping them underneath, where they can be crushed or suffocate. In South Australia, there were seven deaths involving quad bikes and side-by-side vehicles across 2024 and 2025.

The decision followed public consultation from April to June 2026 and an independent economic impact analysis. Safe Work Australia says that analysis found the reforms are expected to reduce deaths and serious injuries from quad bike use at work, with the estimated benefits outweighing the overall costs of putting them in place.

Is any of this law yet?

The amendments to the model WHS Regulations are not in force. As at 20 November 2026, Safe Work Australia has not published those amendments, and no commencement date has been announced. That does not mean there are no specific quad bike rules anywhere in Australia. Queensland already regulates workplace quad bike age, helmets and passengers (Work Health and Safety Regulation 2011 (Qld) ss 226A to 226C). Tasmania already regulates workplace helmets, training and passengers (Work Health and Safety Regulations 2022 (Tas) r 216A). A narrower operator protection device rule already applies under the Consumer Goods (Quad Bikes) Safety Standard 2019 (see below).

Safe Work Australia sets out the next steps for the model amendments:

  1. Drafting. Safe Work Australia will draft amendments to the model WHS Regulations to put the reforms in place.
  2. Approval. WHS ministers must approve the amendments before they are published.
  3. Transition. A 12-month transition period is proposed from publication, to give businesses time to prepare.
  4. Adoption. The model WHS Regulations are a template, not law in themselves. Each state and territory that uses the model laws has to make the changes in its own regulations before they apply there, and timing can differ between jurisdictions.

No date has been announced for the draft amendments or for publication. The 12-month transition is a proposal, not a fixed start date.

What about Victoria?

Victoria does not use the model WHS laws. Workplaces there are covered by the Occupational Health and Safety Act 2004 (Vic) and the Occupational Health and Safety Regulations 2017 (Vic). Amendments to the model WHS Regulations do not change Victorian law on their own. If you run quad bikes in Victoria, check WorkSafe Victoria directly for its current guidance and any announcement about these reforms. Safe Work Australia's resources page lists WorkSafe Victoria's handbook Quad bikes on farms: A handbook for workplaces.

What the law already requires

The agreed reforms would add new rules in the model WHS Regulations, but the general duty behind them is not new. Under the model WHS laws, a person conducting a business or undertaking (PCBU) must eliminate risks to health and safety so far as is reasonably practicable, and if that is not reasonably practicable, minimise them so far as is reasonably practicable (model WHS Act ss 17 and 19). In Victoria, the equivalent employer duty is in the Occupational Health and Safety Act 2004 (Vic) s 21. Safe Work Australia applies that duty to quad bikes directly: "As a PCBU, you must, so far as is reasonably practicable, eliminate risks associated with using quad bikes."

Workers have duties too. Safe Work Australia says workers must take reasonable care of their own safety and that of others in the workplace. That reflects the worker duty in the model WHS Act s 28: take reasonable care for their own health and safety, take reasonable care that their acts or omissions do not adversely affect others, comply with reasonable instructions, and cooperate with reasonable policies and procedures.

One rule about the bikes themselves is already in force. Since 11 October 2021, the Consumer Goods (Quad Bikes) Safety Standard 2019 has required operator protection devices (OPDs) to be fitted to new general use quad bikes and to imported second-hand general use quad bikes. Safe Work Australia says that if you buy a quad bike fitted with an OPD, you should not remove it, and if you do, you must replace it with something that gives equivalent or greater protection. The safety standard is administered by the Australian Competition and Consumer Commission (ACCC).

So, in jurisdictions that do not already have a more specific rule, the reforms would turn several things regulators already advise into specific rules for workplaces. Doing them now is a reasonable way to meet your current duty, and it means less change if the model amendments are adopted.

What to do now

These steps follow Safe Work Australia's current quad bike guidance and the general duties above. They are not the agreed model amendments, which are not in force yet. In Queensland and Tasmania, helmets and passenger restrictions (and in Queensland, a minimum age) are already legal requirements, so follow those provisions as well as this guidance. Work out what is reasonably practicable for your workplace, terrain and tasks.

1. Ask whether a quad bike is the right vehicle

Safe Work Australia suggests considering whether a quad bike is the right vehicle for the job before you use one. A side-by-side vehicle keeps the operator seated and has extra safety features such as seat belts, and a motorbike may suit some tasks better. Removing the quad bike from a task is the strongest control, if it is practicable.

2. Fit or keep operator protection devices

List every quad bike used for work and note which ones already have an OPD. Safe Work Australia's guidance includes retrofitting an OPD to an existing quad bike without rollover protection. OPDs reduce the risk of serious crush injuries and deaths if a quad bike rolls over. Don't remove a factory-fitted OPD. Some jurisdictions offer rebates towards quad bike safety improvements, so ask your WHS regulator what you may be eligible for.

3. Make helmets the rule

Safe Work Australia's advice is to always wear a helmet that fits well when riding a quad bike. It also says that if you ride on a public road, the helmet must comply with AS/NZS 1698:2006 Protective helmets for vehicle users or United Nations Economic Commission for Europe (UNECE) Regulation 22.05, and that these helmets meet the requirements for on-road and off-road use. Supply helmets, set the expectation, and supervise it.

In Queensland, the person with management or control of a workplace quad bike must take all reasonable steps to ensure the operator, and any passenger, is wearing a crash helmet (Work Health and Safety Regulation 2011 (Qld) s 226A; workers have a matching duty under s 226B, and an approved motorbike helmet is required in the areas listed in s 226C). In Tasmania, a person must not use a workplace quad bike unless they are wearing an approved helmet, and a helmet must be available for use (Work Health and Safety Regulations 2022 (Tas) r 216A).

4. No passengers on operator-only bikes

Safe Work Australia says carrying passengers on single-operator quad bikes increases the risk of rollover, and passengers should only be carried on quad bikes designed to take them. Check the manufacturer's information for each bike and make the rule clear to everyone who rides.

The same Queensland and Tasmanian provisions already restrict passengers to bikes designed to carry them.

5. Keep under-16s off adult quad bikes

Safe Work Australia says almost 1 in 6 fatal quad bike incidents involve people under 16, and that you should never allow people under 16 to ride adult-sized quad bikes. On farms and family businesses, that includes children and visitors, not only workers.

In Queensland, the person with management or control must also take all reasonable steps to ensure the operator and any passenger is at least 16, or a different minimum age recommended by the manufacturer (Work Health and Safety Regulation 2011 (Qld) s 226A). The agreed national reform would set a workplace age of 16 with no manufacturer alternative, and it would apply more broadly than Safe Work Australia's current advice about adult-sized bikes. That national reform is not in force yet.

6. Control terrain, loads and towing

Quad bikes have a high centre of gravity. Safe Work Australia advises riding on flat, stable terrain, and notes that rocky, steep, uneven, sandy or muddy ground increases risk. It also advises avoiding towing attachments and loads on the front or rear racks where possible, especially liquid loads that shift on corners and slopes. Mark no-go areas and set load limits in line with the manufacturer's information.

7. Train riders and keep evidence

Safe Work Australia says riders can get general training from suppliers, manufacturers and industry training providers, or complete a national unit of competency through a registered training organisation (RTO). It notes that a WHS regulator may ask to see a statement of attainment, or equivalent, to show a rider knows how to operate a quad bike safely. Some states and territories subsidise training, so ask your regulator. Active riding techniques, such as shifting body weight on corners and slopes and keeping both hands and both feet in place, are part of what riders learn.

8. Write it down and talk it through

Put your controls into a job safety analysis (JSA) or similar risk assessment, go through it with the people who ride, and review it when something changes: a new bike, new terrain, a new rider or an incident. A written record shows how you worked through the risks with your crew.

How our JSA can help

Our Quad Bike and Side-by-Side JSA is an editable Word template that breaks the task into 7 steps: plan and prepare and confirm competency; pre-start inspection; fit personal protective equipment (PPE); load and assess terrain; ride and operate the vehicle; cross obstacles and slopes; and park, shut down and demobilise. For each step it sets out the hazards, a risk rating, the control measures and the residual risk, with fields for your company, site, date, personnel and crew sign-on.

It is a national template and a starting point. Check the hazards and controls against your own bikes, terrain and tasks, add the controls in this guide that fit your workplace, and have it reviewed by a competent person. A JSA is not a Safe Work Method Statement (SWMS); see SWMS vs JSA and what is a JSA?. For a quick check before riding, see what is a Take 5?.

Common questions

Are the quad bike safety reforms law yet?

The model WHS amendments agreed on 17 November 2026 are not in force yet. Safe Work Australia will now draft those amendments, ministers must approve them before they are published, and each state and territory that uses the model laws must then adopt them. A 12-month transition period from publication is proposed. Some overlapping workplace rules already apply in Queensland (Work Health and Safety Regulation 2011 (Qld) ss 226A to 226C) and Tasmania (Work Health and Safety Regulations 2022 (Tas) r 216A).

Will helmets be compulsory on quad bikes at work?

Mandatory helmets at work are one of the agreed model reforms, but those model amendments are not in force yet. Helmets are already a workplace legal requirement in Queensland (Work Health and Safety Regulation 2011 (Qld) ss 226A to 226C) and Tasmania (Work Health and Safety Regulations 2022 (Tas) r 216A). Safe Work Australia already advises always wearing a well-fitting helmet when riding a quad bike, and says a helmet worn on a public road must meet AS/NZS 1698:2006 or UNECE Regulation 22.05.

Will under-16s be banned from riding quad bikes at work?

One of the agreed model reforms would restrict the use of quad bikes in the workplace to people aged 16 and over. Those model amendments are not in force yet. Queensland already requires a minimum operator and passenger age of 16, or a different age recommended by the manufacturer (Work Health and Safety Regulation 2011 (Qld) s 226A). Safe Work Australia already advises never allowing people under 16 to ride adult-sized quad bikes.

Do workplace quad bikes need an operator protection device now?

Since 11 October 2021, a national consumer safety standard has required operator protection devices on new general use quad bikes and imported second-hand ones. The reform would extend this to all quad bikes in the workplace, but it is not law yet. Under your current duty, retrofitting an operator protection device is one of the controls Safe Work Australia lists.

When will the new quad bike rules start?

No start date has been announced for the model amendments. They still have to be drafted and approved, a 12-month transition from publication is proposed, and each jurisdiction that uses the model laws then has to adopt them in its own regulations.

Do the reforms apply in Victoria?

Victoria does not use the model WHS laws. Its workplaces are covered by the Occupational Health and Safety Act 2004 (Vic) and the Occupational Health and Safety Regulations 2017 (Vic), so changes to the model WHS Regulations do not apply there on their own. Check WorkSafe Victoria for its current position.

Sources: Safe Work Australia, "WHS ministers agree to strengthen quad bike safety at work", 17 Nov 2026, SafeWork SA, "Quad bike safety to be strengthened", 18 Nov 2026, Safe Work Australia, Quad bikes, Safe Work Australia, Quad bikes (agriculture duties tool), Safe Work Australia, Quad bikes and Work Health and Safety Regulation 2011 (Qld), ss 226A to 226C (quad bike age, helmets, passengers), current as at 29 March 2026; checked by the Legal Content Auditor (REVIEW_2026-11-20_news.md).

Start from a proper SWMS, not a blank page

State-specific, editable templates written for your state. Download instantly, then make it yours for the job and the site.

This guide is general information, not legal or safety advice, and does not guarantee compliance. Laws and site conditions vary, so always check your state regulator and have documents reviewed by a competent person.